Development of firmware for two embedded devices.
Both are based on Nordic NRF52840
Must be running in the “Long range mode”
1.-Beacon with two pushbuttons. Must send a beacon with a different info based on a button push. One push must send “ON” and the other “OFF”
We should implement an “all-off” state via the push of both buttons. Then, the unit should pass to a “deep-sleep” state. (for air transport)
2.-The other will receive the info sent by the beacons, either with “ON” or “OFF” info and will output this info and identity via an UART port.
Will only output the info for beacons of our project (perhaps we should use a custom UUID to detect them?)
Both devices are custom designed but based on Raytac mdbt50q module.
Program and softdevice info should be uploaded via SWD pins provided in the PCB
Preferably, Arduino IDE used with custom or modified bootloader.
Otherwise full Nordic dev kit with Segger can be used.
Will need detailed instructions for uploading with any of these tools.
14 freelancers están ofertando el promedio de €388 para este trabajo
Hello, I am interested in your project. I have more than five years expirience with nRF51/52, including beacons. I have all development boards and tolls. Best regards, Vyacheslav.
Good day! I can help If there are models or prototypes and SWD programmer. If you need to develop a scheme, I can also help. If you need to develop a printed circuit board, also Contact us