Arduino manufacturing robotic equiptment

Cerrado Publicado hace 5 años Pagado a la entrega
Cerrado

I have a linear actuator with a nema 17 stepper motor, as well as two are cylinders to drop a part into a whole. one cylinder grabs the part and the other controls the z axis, ( up and down ) so to speak. Probably would not take a good programmer long and I think I am intelligent enough to relay what I want so it can all be done over freelancer. So if that makes sense, there is a linear rail controller by stepper motor. It makes maybe 4 inches from picking up part to dropping it in while. I am going to install and infrared sensor so it can be timed when it needs to drop the part into the whole. Once again two air cylinders controlled by a solenoid, one grabbing the part (cyl1) then one sucking up 2 inches for clearance(cyl2), then dropping back down again after clearing plate(cyl2) followed by dropping part into the hole(cyl1) before returning home to pick up next part.

Arduino Ingeniería eléctrica Electrónica Tareas generales LabVIEW

Nº del proyecto: #18005363

Sobre el proyecto

Activo hace 5 años

Ubicación: Charlotte, United States