Complete PCB design and Firmware for RF transmitter and reciever
$30-250 AUD
Pagado a la entrega
RF Receiver:
434,000 MHz
2 Channel Wireless Receiver
9 – 32VDC Operating Voltage
Positive Output (Latched until Negative unlatch received)
Unlatch Negative input
Negative Output Channel 1 (Momentary) 2A
Negative Output Channel 2 (Momentary) 2A
Built in Buzzer (Buzzer signal when RF signal received, NO SIGNAL if LATCH ON)
Buzzer Specs: PCB Mount; 3500Hz; >90dB;
Learn Button ( PCB mount button )
Pair up to 50 individual transmitters
RGB Status LED
Should be resistant against irradiated and induced electro-magnetic noise
Learn Mode should reduced range to 50cm.
Transmitter Low Battery LED.
Low Battery LED should illuminated if last received transmitter battery is low.
All inputs and outputs should include short circuit protection, over current protection, reverse polarity protection.
Connector specifications will be supplied.
PCB Size limitations: Width 55mm, 45mm usable. Length <80mm
more details will be shared in the inbox
Nº del proyecto: #22393230
Sobre el proyecto
9 freelancers están ofertando un promedio de $243 por este trabajo
Hello sir, I have experience in designing electronics circuits and can develop hardware compatible smartphone and PC based apps. I also have done a lot of IoT projects and can transform your idea into a fully working p Más
Hi, I hope you are doing well. I have expertise in RF based embedded projects. I have understood your requirements. I would to ask few questions. Please send me message for further discussion. Looking Forward, Khawa Más
I am an electronic engineer with 20 years of experience. I've done a lot of projects so far. I use Altium for electronic design. I use the datasheet of ICs to create a library and schematic. I can give you examples if Más
Hello Friend, I read your post and am interested in your project. I am an electrical engineer with 15+ years of automotive experience. I am confident I can get this job done for you. I have design numberous PCB's i Más
Hello! I am Mechatronics engineer. I have experience working with different microcontrollers, PCBs and integration of sensors. I have read your description and I think it matches my expertise. I would like to work with Más
Hello Employer When I was Electrical engineering student I always did projects like this and I am doing projects like this all the time. If you choose me you'll never regret.
