PCB design -- 3

Hello, I am PhD Researcher in Electrical Engineering with specialization in Control Systems (Linear and Nonlinear Control Systems). I have Master's degree in Electrical Engineering and Bachelor's Degree in Electronics Engineering. My Area of Specialization is Control System & Unmanned Aerial Vehicles (UAVs) and My Major skills are PCB design, Arduino, c/c++ MATLAB, Simulink,FPGA Mathematics, Statistics, FPGA,verilog/vhdl/Numerical Methods, Numerical, Logical and Verbal Reasoning, Modeling, Design and Analysis. I have excellent skills in these: * SHL (Numerical+Logical+Vebal Reasoning), Korn Ferry * MATLAB * Simulink * Mathematica * Logisim * Pspice * Quite Universal Circuit Simulator (QUCS) i'll be looking forward to have more discussion with you on the project.

Hello there. I hope to work with you because your project is very familiar for my past works. I have 3+ years experiences in Electrical Engineering & PCB Layout & Circuit Design. Hope further discussion about your project more specific. Regards.

Hi, I am a electronics and communication engineer with more than 2 years of experience in PCB and Circuit Designing. In past I have worked on many projects related to this field. Here are the softwares I have worked on for PCB/Circuit Designing :- 1. Kicad 2. Altium 3. Eagle 4. Easyeda 5. Proteus (I use this for simulation as well) 6. PADS 7. Pcb wizard I can use any software mentioned above as per your requirements. Some projects I have worked on previously:- 1. Bluetooth Speaker 2. Bluetooth Gaming Controller 3. Gaming pad based on ESP32 4. Home automation PCB (based on multiple channel relays) 5. Power Bank 6. Some IoT based project. This are some projects I have worked on. There are many more. So Let's discuss your requirements in the chat. Thanks. Please have a look at my profile once. Jaibhan Singh Gaur.

hello sir, how are you. I read your proposal and i am interested in this project. SIr i can give you a circuit that can rapidly charge and discharge 60 capacitor individually. I am an Embedded engineer (ARM, PIC, AVR, Arduino, SOC BLE (bluetooth) chips, ZigBee, WiFi, GPS, LED, LCD display etc.) and PCB designer (Altium, KiCad, Orcad), 3D Modeling. You can check my profile for more information. I can do this project as per your requirement. I hope you will consider me for this project. I am waiting for your reply...... thanks with regards Preetpal Singh

Hello, I'm Hisham Ramadan, Electronics and communication engineer. I always had an intense passion for technology, control systems, and embedded systems, and luckily I had the opportunity to work with my family alongside my studies for more than ten years in the same field forming a good technical skills until I completed my university studies. Because of to the technical skills I gained, I had the ability to work on various projects as Designing and installations of control and protection systems for CAT generators Supervision on installations for water treatment plant stations with ICS company. Electrical installations in dohler egypt factory. Electrical installations in Mars egypt factory extension project. Achivements: By the end of 2020, it became for the first time to use my electronic circuits as an alternative and effective solutions in the control and protection circuits of CAT generators. It was also used in more than 100 self-sterilizing gates in cooperation with Green Line Company. Also its used in smart home systems and in many other industrial applications. hope to get in touch with you to discuss further steps to make a good business with you. Regards; Hisham Ramadan

Hi, I am electronics engineer with 2 years of experience. I have designed compressed and reliable PCBs for companies. Regards, Angad Kumar