ESP8266 broadcasting SSID contaning analog and IO state 10min interval
$30-250 USD
Pagado a la entrega
Hi freelancers, I need quick development on ESP8266 , can use open Espressif’s IDE for development.
I need a ESP8266 when powered, starts AP mode using 802.11b 11Mbps(to give more range, or maybe lower rate to more range. need tests) and broadcast SSID containing a message including analog and IOs states, dynamic SSID i call it.
Message SSID can be sensor#001,variable=80,IN=0101
For start only monitor analog in and 4 inputs.
The sequence is power up, setup AP 802.11b, broadcast SSID containg data above, stays on 2min, than goes to deep sleep for low power consumption. After that wake up every 10min and broadcast the message with analog and four inputs during 30s (maybe need to ajust this time variables)
I will need the firmware ready to uplod to esp8266 and source code.
I will pay $50 for this job, but if good job I will need more development for a network of sensors and actuators. So $50 at begining and you will be choosed to get next tasks.
Thanks for your time,
Vitor
Nº del proyecto: #18115602
Sobre el proyecto
Adjudicado a:
Hi! I have worked in projects using the ESP8266 and I alredy have a lot of them with me to test the firmware before send it to you. I can do it 100%, what do you think? Can we talk more about it? Regards
5 freelancers están ofertando un promedio de $81 por este trabajo
Hello sir, I have experience in designing electronics circuits and can make your project. i will make your project completely on my side and will deliver a working prototype. I can also develop hardware compatible and Más
I worked with esp8266 and esp-idf on a couple of projects, and I have an esp8266 board that I can use for testing