solidworks flow simulation - MAH270914_18025_35672

hello i need the my solidworks design to show pressure loss at each feature in the system. i have built the system and can provide what i have done already. globe vavle must have a k value of 10 pipes made of copper internal diameter of the pipe is 13.7mm sudden expansion section is 26.4mm 3 bend 150mm, 100mm, and 50mm and 1 90 degree mitre all shown in the system ive already done flow rate of 60L/min manometer so you can visual see the the changes in pressure would be ideal and can see the turbulence caused by each feature . hello adim, please find attached the revavent information for my project flow rate 60L/min globe vavle must have a k value of 10 made of copper internal diameter of the pipe is 13.7mm sudden expansion section is 26.4mm 3 bend 150mm, 100mm, and 50mm and 1 90 degree mitre and the same system with a gate valve as discussed in chat manomiters at each feature to show preasure losses and beable to show the flow turbulances [login to view URL] ok i hope this helps. system gate [login to view URL] system glabe [login to view URL] i hope this helps. it would be best if you could open the original files i sent as they have the valves moving to the correct positions Files : [login to view URL] [login to view URL] hello adim, please find attached the revavent information for my project flow rate 60L/min globe vavle must have a k value of 10 made of copper internal diameter of the pipe is 13.7mm sudden expansion section is 26.4mm 3 bend 150mm, 100mm, and 50mm and 1 90 degree mitre and the same system with a gate valve as discussed in chat manomiters at each feature to show preasure losses and beable to show the flow turbulances will i need to upload each part individualy? please find attached the solid works files note: assem system file is the system already constructed and will be sent last Requirements: fluid=water flowrate=60L/min pipeing material = copper k vaule of globe valve fully open = 10 k vaule of gate valve fully open = 0.2 k vaule of gate valve half open= 5.6 100mm pipe diamiter =13.7mm sudden expansion section= 26.4mm 1st bend =50mm 2nd bend =100mm 3rd bend =150mm 90 degree mitre all the solid works parts have been made and uploaded to his page all i need is the someone to go into solid works flow and design it so that it shows the preasure losses in the system as its running. i will do all the rendering after this is done 50mm bend length=78.54mm 100mm bend length= 157.08mm 150mm bend length=235.62mm total length of system (bends included)=2021.24mm please find attached gate vavle system Note. the gate valve has been limited to open from half open to fully open it does not shut fully this is intensional Deadline: 22 Sep, 11 AM