PCB Board Layout Design for Prototype
$30-250 USD
Pagado a la entrega
1. Telit GE865-QUAD GSM/GPRS
2. Telit Jupiter JN3 GPS Receiver Module
2. LIS331HH Accelerometer via the I2C or SPI ports
3. VQFN8 Embedded SIM Chip switchable to standard SIM Card Slot via manual DIP switch at the side of the board
and via digital I/O switch
5. SIM Card Slot
6. Battery charger for Lion Battery.
7. Ipex antenna connector for GE865-Quad and JN3.
8. Expose solder points for 2 UART ports at same side as I/Os.
9. Expose solder points for for 10 I/O, 2 ADCs, DAC port/s at the same side of the board
10. Expose 12 VDC power and Batter Connector at opposite side as I/Os.
11. Smallest possible "square" footprint
You should have prior experience in working with the Telit GE865.
Datasheets attached.
Best regards,
Norman
Nº del proyecto: #2597688
Sobre el proyecto
18 freelancers están ofertando un promedio de $779 por este trabajo
Hi, I have a huge experience in similar applications (SIM, GSM modules, etc) Please provide more details about mechanical requirements if any. Regards, Michal
Hi. I'm interested in your project. I have extensive experience in 3d modelling using solidworks software. Thanks
Hi, I would like to work with you. And I will come up with the new PCB design. Please see your personal inbox for the Design Proposal. Thanks!
Dear Sir, I have made similar project, with Telit modules, for a helicopter navigation system with satellite communication. I can help you with that. Regards, Lyuben Iliev.
