Send commands To vehicle control units! -- 2

Hi! I am an Electronic engineer, microcontroller, C programming expert having past experiences with arduino, pic, AVR, chipkit and Texas instruments microcontrollers I am waiting for you over the chat. Thank you!

I am an electrical and electronics engineer I have very good experience in microcontrollers programming, arduino.., I have gone through your requirements and I am sure that I can do this project perfectly, kindly send me a message in chat box then we can discuss extensively about the project and price. I am interested in taking this task up for you and I will be grateful if I am been awarded this project to prove my ability and earn more trust on this platform while beating deadlines and reasonable pricing, we can discuss and adjust price in chat box. I have read your job description carefully and I am confident I can finish your job without fail

Hi there.. Well, I think there is magnetic breaks that are controlled via microcontrollers, the mechanical breaks far as I think it doesn't have direct ways to control with microcontroller. I have done a system before that can stop the whole car, but not the break.. I have been doing microcontrollers and embedded systems since 2012, I hope we get to chat. Regards

I can definitely handle this job as I have profound experience in working with microcontrollers and control systems. I have worked as an embedded C coder in the Robotics team of our college for two years and have secured 5th rank in India at ABU ROBOCON 2019 held at IIT DELHI. I have coded a manual robot on AVR 2560 microcontroller, have interfaced sensors using SPI , I2C, UART. I have worked on the controller system of the mobile drives which includes the three wheel, four wheel and swerve drive. Currently I have coded Ventilator modes of the Ventilator namely PCSIMV, VCSIMV, BiPAP, PRVC on Teensy 4.0 microcontroller.