Architectural Design & Technology (REVIT) - open to bidding

Assignment Details and submission requirements You are provided with dimensioned drawings of a single family house. Using these drawings you are to analyse the building in order to understand it 3-dimensionally, and to calculate any missing dimensions, using your sketchbook as necessary, then to construct and present A1 size .pdf drawings sheets containing the following: 1. Both principal floor plans at scale 1:100 2. Two cross sections at scale 1:100 (based on the two provided) 3. Three elevations at scale 1:100 (two long and one short elevation) 4. Eaves detail at scale 1:5 5. Internal rendered perspective 6. External rendered perspective 7. Your sketchbook showing all analytical drawings Drawings should be carefully arranged on no more than 2X A1 sheets. Do not submit more than two A1 sheets. All work must be placed in correctly formatted A1 sheets and be saved as a PDF file ready to plot. You are NOT required to redesign or alter the house in any way. This assignment is designed to test your modelling accuracy and your understanding of the drawings provided. You may choose internal finishes as you wish. The construction and materials of the house are to be as follows: Roof: Slates on 38 x 25mm timber battens on 125 x 50 swd rafters @ 400 centres External Walls: 300mm thick cavity wall comprising 100mm external facing brick; 50mm clear cavity; 50mm insulation; 100mm concrete blockwork inner skin with plaster finish. (Note: the projecting bathroom walls at first floor are clad externally in timber boarding) Upper floor: 200 x 50mm joists @ 400 centres with 20mm floorboards and 12.5mm plasterboard ceiling with plaster finish. Ground floor: 50mm screed on 125mm concrete slab on 75mm insulation board Internal partitions: 100mm thick blockwork with 13mm plaster finish each side (Note: the internal garage walls are left as fair-face blockwork to garage side and plastered to house side)