ESP32 TTGO Shield
$250-750 USD
Pagado a la entrega
We need the design for a PCB to be used as Shield for ESP32 TTGO Lora V2.0. The shield should be according to the schematic attached and according to the information on this description.
ESP32 TTGO Lora V2.0: ([login to view URL])
Load Cell Amplificator HX711: ([login to view URL])
Temperature Sensor DHT22: ([login to view URL])
5 and 4 pin connector: [login to view URL]
PCB max size: 170x170 mm
Deliverables Files:
- Eagle SCH and BRD Files
- SCH and BRD in PDF Format
- 3D Model Step and PDF File
- GERBER Files for fabrication
- BOM List xlsx file
Milestones:
- 30% when full schematics approved
- 50% when pcb design approved and all files delivered
- 20% when fabrication is started by manufactured
Nº del proyecto: #17305989
Sobre el proyecto
16 freelancers están ofertando un promedio de $509 por este trabajo
Hi, I am electronic engineer and I have used Eagle over 6 years. I have analyzed the sch file of the Eagle you have many HX711 chip and as I understand it need to be revised because LM2596 seems so simples without cap Más
Hi, I hope you are doing well. I have experience with ESP32, LoRa, HX711 Load Cell Amplifier, and DHT22, DHT11 Temp and Humidity Sensor Module. I have reviewed your project details which requires a PCB design. Más
Hi I am interested to your project. I am familiar with electronics, microcontroller as well as PCB design by Eagle. i will not provide any 3D model. Thanks.
Hi I have almost two years of experience in PCB designing (ESP32 board Designed, Sensor Board) and can make PCB in eagle software in short time maximum two days. I would like to work on your project.
