LED programming and circuit design

Looking for individuals who are interested in creating interesting lighting effects for architectural models. From the conception of writing the program needed for the leds to behave as intended, designing the pcb needed for the lights to work, to designing the entire circuit and coming up with the circuit schematic. BREAKDOWN OF PROJECT Dimensions: Measurements are in mm (lxbxh) 2 components – architectural model with a case below to hold electronic components Architectural model (brass): 650x450x210 Approx. Case (wood): 730x530x600 Approx. All electronics will be placed in the case but have wires going up into the architectural model above and the lights are placed around in the model (picture attached in post for further understanding of model) The project is to light up an architectural model that has 4 sections of lights: A) Main LED (warm light) that gradually lights up B) 2 groups of LEDs (white light) that can be placed far apart that light up normally C) LED (white light) that can have a gradual pulsing upward movement to simulate a fountain water moving up and down D) Fiber optic lighting (warm light) with cables that can extend sparsely around the perimeter of the architectural model The sequence will be as follows: 1. On button press- on 2. Section A and D will gradually start up 3. Section B will start up 4. Section C will gradually start up 6. On button press – off Battery requirements: Battery recommendation is required. Lighting circuit should be able to be powered for a minimum of 4 hours on one charge. Required deliverables: Electrical components needed to achieve lighting effects, schematic of circuit, list of all electrical components needed to achieve complete circuit. If you are in contact with electrical component suppliers that can provide everything the circuit requires, do let us know for further discussion.